rendered paste bodyUncompressing Linux....................................................................................... done, booting the kernel.
Linux version 2.6.26 (andrea@mizar) (gcc version 4.3.3 (GCC) ) #1 PREEMPT Wed Dec 2 03:21:56 CET 2009
CPU: XScale-PXA255 [69052d06] revision 6 (ARMv5TE), cr=0000397f
Machine: SHARP Husky
Memory policy: ECC disabled, Data cache writeback
On node 0 totalpages: 16384
DMA zone: 128 pages used for memmap
DMA zone: 0 pages reserved
DMA zone: 16256 pages, LIFO batch:3
Normal zone: 0 pages used for memmap
Movable zone: 0 pages used for memmap
Memory clock: 99.53MHz (*27)
Run Mode clock: 199.07MHz (*2)
Turbo Mode clock: 398.13MHz (*2.0, active)
CPU0: D VIVT undefined 5 cache
CPU0: I cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
CPU0: D cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256
Kernel command line: root=/dev/mmcblk0p1 rootfstype=ext2 rootwait console=tty1 console=ttyS0,115200n8 noinitrd debug
PID hash table entries: 256 (order: 8, 1024 bytes)
Console: colour dummy device 80x30
console [tty1] enabled
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 64MB = 64MB total
Memory: 62092KB available (2496K code, 189K data, 84K init)
Calibrating delay loop... 397.31 BogoMIPS (lpj=1986560)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 624 bytes
NET: Registered protocol family 16
Sharp Scoop Device found at 0x10800000 -> 0xc4806000
Switched to high resolution mode on CPU 0
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
NET: Registered protocol family 1
PXA CPU frequency change support initialized
JFFS2 version 2.2. (NAND) (SUMMARY) 2001-2006 Red Hat, Inc.
msgmni has been set to 121
io scheduler noop registered
io scheduler anticipatory registered (default)
Corgi Backlight Driver Initialized.
Found w100 at 0x08000000.
Console: switching to colour frame buffer device 80x30
fb0: w100fb frame buffer device
pxa2xx-uart.0: ttyS0 at MMIO 0x40100000 (irq = 22) is a FFUART
console [ttyS0] enabled
pxa2xx-uart.1: ttyS1 at MMIO 0x40200000 (irq = 21) is a BTUART
pxa2xx-uart.2: ttyS2 at MMIO 0x40700000 (irq = 20) is a STUART
pxa2xx-uart.3: ttyS3 at MMIO 0x41600000 (irq = 7) is a HWUART
loop: module loaded
Uniform Multi-Platform E-IDE driver
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
Sharp SL series flash device: 800000 at 0
Using static partition definition
Creating 1 MTD partitions on "sharpsl-flash":
0x00120000-0x007f0000 : "Boot PROM Filesystem"
pccard: PCMCIA card inserted into slot 0
pcmcia: registering new device pcmcia0.0
NAND device: Manufacturer ID: 0xec, Chip ID: 0x79 (Samsung NAND 128MiB 3,3V 8-bit)
Scanning device for bad blocks
Bad eraseblock 32 at 0x00080000
Bad eraseblock 1440 at 0x01680000
Creating 3 MTD partitions on "sharpsl-nand":
0x00000000-0x00700000 : "System Area"
0x00700000-0x03c00000 : "Root Filesystem"
0x03c00000-0x08000000 : "Home Filesystem"
pxa2xx_udc: version 30-June-2007
input: Corgi Keyboard as /devices/platform/corgi-keyboard/input/input0
sharpsl_rc_init
input: Corgi Touchscreen as /devices/platform/sharp-scoop/corgi-ssp/corgi-ts/input/input1
sa1100-rtc sa1100-rtc: rtc core: registered sa1100-rtc as rtc0
I2C: i2c-0: PXA I2C adapter
Registered led device: corgi:amber:charge
Registered led device: corgi:green:mail
TCP cubic registered
XScale DSP coprocessor detected.
Probing IDE interface ide0...
mmc0: new SD card at address 9ffc
mmcblk0: mmc0:9ffc SD01G 992000KiB
mmcblk0: p1 p2 p3
hda: TOSHIBA THNCF512MMA, CFA DISK drive
ide0 at 0xc4820000-0xc4820007,0xc482000e on irq 81
hda: max request size: 128KiB
hda: 1000944 sectors (512 MB) w/2KiB Cache, CHS=993/16/63
hda: hda1
ide-cs: hda: Vpp = 0.0
sa1100-rtc sa1100-rtc: setting system clock to 1970-01-01 00:00:30 UTC (30)
VFS: Mounted root (ext2 filesystem) readonly.
Freeing init memory: 84K
INIT: version 2.86 booting
Loading /etc/keymap-2.6.map
Please wait: booting...
Starting udev
NET: Registered protocol family 23
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
Remounting root file system...
Unknown HZ value! (81) Assume 100.
ALSA: Restoring mixer settings...
Configuring network interfaces... /usr/sbin/alsactl: load_state:1608: No soundcards found...
ifconfig: SIOCGIFFLAGS: No such device
ifconfig: SIOCGIFFLAGS: No such device
eth0 No such device
ifconfig: SIOCGIFFLAGS: No such device
done.
Starting portmap daemon: portmap.
Unknown HZ value! (83) Assume 100.
net.ipv4.conf.default.rp_filter = 1
net.ipv4.conf.all.rp_filter = 1
Wed Dec 2 04:50:00 UTC 2009
Checking for built-in Bluetooth: no
Configuring ppp-dialin
Configuring dbus
System startup links for /etc/init.d/dbus-1 already exist.
Configuring ppp
Configuring avahi-autoipd
Configuring angstrom-libc-fixup-hack
Configuring avahi-daemon
System startup links for /etc/init.d/avahi-daemon already exist.
Configuring update-modules
Configuring libnss-mdns
Bluetooth: Core ver 2.11
NET: Registered protocol family 31
Bluetooth: HCI device and connection manager initialized
Bluetooth: HCI socket layer initialized
Bluetooth: L2CAP ver 2.9
Bluetooth: L2CAP socket layer initialized
Bluetooth: HIDP (Human Interface Emulation) ver 1.2
IrCOMM protocol (Dag Brattli)
Bluetooth: RFCOMM socket layer initialized
Bluetooth: RFCOMM TTY layer initialized
Bluetooth: RFCOMM ver 1.8
ASoC version 0.13.2
wm8731: WM8731 Audio Codec 0.13
asoc: WM8731 <-> pxa2xx-i2s mapping ok
INIT: Entering runlevel: 5
Starting system message bus: dbus.
Creating Dropbear SSH server RSA host key.
Will output 1024 bit rsa secret key to '/etc/dropbear/dropbear_rsa_host_key'
Generating key, this may take a while...
Public key portion is:
ssh-rsa AAAAB3NzaC1yc2EAAAADAQABAAAAgwCUDGhSiI9NyJQaoiNG6ns+MHtktx2L+BsxqVhZKAVG0f/A+Hgjmypyj+ViiUhL2cKAZ5gAJiFe9Fu7XJYZ320W7UJk7JQbLE2lvybGYltzyox1eCT0ZzHozWHJvI5y1K9i3Jf62BQHax2xdBI7RWFvaz/hxjGA/F+IO90Vi4TYySzN root@c7x0
Fingerprint: md5 d7:b8:a8:10:fa:4d:80:6c:b8:30:9d:e0:5a:00:c6:0b
Starting Dropbear SSH server: dropbear.
Starting advanced power management daemon: apmd[1409]: apmd 3.2.1 interfacing with apm driver 1.13 and APM BIOS 1.2
apmd.
Starting syslogd/klogd: done
* Starting Avahi mDNS/DNS-SD Daemon: avahi-daemon
[ ok ]
Loading [g_ether]
ether gadget: using random self ethernet address
ether gadget: using random host ethernet address
usb0: Ethernet Gadget, version: May Day 2005
usb0: using pxa2xx_udc, OUT ep2out-bulk IN ep1in-bulk STATUS ep6in-bulk
usb0: MAC 92:be:90:dd:c0:e1
usb0: HOST MAC 6e:90:e2:60:a6:7f
usb0: RNDIS ready
Starting Zaurusd
NET: Registered protocol family 17
Unknown HZ value! (84) Assume 100.
input: Touchscreen offscreen keys as /devices/virtual/input/input2
Using [corgi-bl] backlight driver
### on 31 ###
cat: can't open '/var/run/last-screen-rotation': No such file or directory
Unknown HZ value! (85) Assume 100.
Unknown HZ value! (85) Assume 100.
Unknown HZ value! (85) Assume 100.
.-------.
| | .-.
| | |-----.-----.-----.| | .----..-----.-----.
| | | __ | ---'| '--.| .-'| | |
| | | | | |--- || --'| | | ' | | | |
'---'---'--'--'--. |-----''----''--' '-----'-'-'-'
-' |
'---'
The Angstrom Distribution c7x0 ttyS0
Angstrom 2009.X-test-20091202 c7x0 ttyS0
c7x0 login: