rendered paste bodyUncompressing Linux........................................................................................ done, booting the kernel.
Linux version 2.6.26 (koen@dominion) (gcc version 4.3.3 (GCC) ) #1 PREEMPT Mon Jun 22 07:21:12 CEST 2009
CPU: XScale-PXA255 [69052d06] revision 6 (ARMv5TE), cr=0000397f
Machine: SHARP Husky
Memory policy: ECC disabled, Data cache writeback
On node 0 totalpages: 16384
DMA zone: 128 pages used for memmap
DMA zone: 0 pages reserved
DMA zone: 16256 pages, LIFO batch:3
Normal zone: 0 pages used for memmap
Movable zone: 0 pages used for memmap
Memory clock: 99.53MHz (*27)
Run Mode clock: 199.07MHz (*2)
Turbo Mode clock: 398.13MHz (*2.0, active)
CPU0: D VIVT undefined 5 cache
CPU0: I cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
CPU0: D cache: 32768 bytes, associativity 32, 32 byte lines, 32 sets
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256
Kernel command line: root=/dev/mmcblk0p1 rootfstype=ext2 rootwait console=tty1 console=ttyS0,115200n8 noinitrd debug
PID hash table entries: 256 (order: 8, 1024 bytes)
Console: colour dummy device 80x30
console [tty1] enabled
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 64MB = 64MB total
Memory: 62092KB available (2504K code, 189K data, 84K init)
Calibrating delay loop... 397.31 BogoMIPS (lpj=1986560)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 624 bytes
NET: Registered protocol family 16
Sharp Scoop Device found at 0x10800000 -> 0xc4806000
Switched to high resolution mode on CPU 0
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
NET: Registered protocol family 1
PXA CPU frequency change support initialized
JFFS2 version 2.2. (NAND) (SUMMARY) 2001-2006 Red Hat, Inc.
msgmni has been set to 121
io scheduler noop registered
io scheduler anticipatory registered (default)
Corgi Backlight Driver Initialized.
Found w100 at 0x08000000.
Console: switching to colour frame buffer device 80x30
fb0: w100fb frame buffer device
pxa2xx-uart.0: ttyS0 at MMIO 0x40100000 (irq = 22) is a FFUART
console [ttyS0] enabled
pxa2xx-uart.1: ttyS1 at MMIO 0x40200000 (irq = 21) is a BTUART
pxa2xx-uart.2: ttyS2 at MMIO 0x40700000 (irq = 20) is a STUART
pxa2xx-uart.3: ttyS3 at MMIO 0x41600000 (irq = 7) is a HWUART
loop: module loaded
Uniform Multi-Platform E-IDE driver
ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
Sharp SL series flash device: 800000 at 0
Using static partition definition
Creating 1 MTD partitions on "sharpsl-flash":
0x00120000-0x007f0000 : "Boot PROM Filesystem"
pccard: PCMCIA card inserted into slot 0
pcmcia: registering new device pcmcia0.0
NAND device: Manufacturer ID: 0xec, Chip ID: 0x79 (Samsung NAND 128MiB 3,3V 8-bit)
Scanning device for bad blocks
Bad eraseblock 32 at 0x00080000
Bad eraseblock 1440 at 0x01680000
Creating 3 MTD partitions on "sharpsl-nand":
0x00000000-0x00700000 : "System Area"
0x00700000-0x03c00000 : "Root Filesystem"
0x03c00000-0x08000000 : "Home Filesystem"
pxa2xx_udc: version 30-June-2007
input: Corgi Keyboard as /devices/platform/corgi-keyboard/input/input0
sharpsl_rc_init
input: Corgi Touchscreen as /devices/platform/sharp-scoop/corgi-ssp/corgi-ts/input/input1
sa1100-rtc sa1100-rtc: rtc core: registered sa1100-rtc as rtc0
I2C: i2c-0: PXA I2C adapter
Registered led device: corgi:amber:charge
Registered led device: corgi:green:mail
TCP cubic registered
XScale DSP coprocessor detected.
Probing IDE interface ide0...
mmc0: new SD card at address 9ffc
mmcblk0: mmc0:9ffc SD01G 992000KiB
mmcblk0: p1 p2 p3
hda: TOSHIBA THNCF512MMA, CFA DISK drive
ide0 at 0xc4820000-0xc4820007,0xc482000e on irq 81
hda: max request size: 128KiB
hda: 1000944 sectors (512 MB) w/2KiB Cache, CHS=993/16/63
hda: hda1
ide-cs: hda: Vpp = 0.0
sa1100-rtc sa1100-rtc: setting system clock to 1970-01-01 00:02:52 UTC (172)
VFS: Mounted root (ext2 filesystem) readonly.
Freeing init memory: 84K
INIT: version 2.86 booting
Loading /etc/keymap-2.6.map
Please wait: booting...
Starting udev
/etc/rcS.d/S03udev: line 50: can't create /tmp/uname: Read-only file system
touch: /tmp/uname: Read-only file system
Remounting root file system...
Cannot create link over existing -/etc/resolv.conf-.
ALSA: Restoring mixer settings...
Configuring network interfaces... /usr/sbin/alsactl: load_state:1608: No soundcards found...
ifconfig: SIOCGIFFLAGS: No such device
ifconfig: SIOCGIFFLAGS: No such device
eth0 No such device
ifconfig: SIOCGIFFLAGS: No such device
done.
Starting portmap daemon: portmapportmap: fork: No such device.
net.ipv4.conf.default.rp_filter = 1
net.ipv4.conf.all.rp_filter = 1
hwclock: can't open '/dev/misc/rtc': No such file or directory
Wed Dec 2 23:46:00 UTC 2009
hwclock: can't open '/dev/misc/rtc': No such file or directory
Checking for built-in Bluetooth: no
Configuring kernel-module-pcnet-cs
Configuring kernel-module-nfs
Configuring kernel-module-slhc
Configuring kernel-module-hostap
Configuring kernel-module-bluetooth
Configuring kernel-module-crypto-algapi
Configuring kernel-module-8250
Configuring kernel-module-michael-mic
Configuring ppp-dialin
Configuring kernel-module-snd-soc-pxa2xx
Configuring kernel-module-ieee80211-crypt-tkip
Configuring kernel-module-ppp-async
Configuring kernel-module-ieee80211-crypt-ccmp
Configuring kernel-module-ircomm
Configuring kernel-module-irlan
Configuring kernel-module-snd-mixer-oss
Configuring kernel-module-snd-page-alloc
Configuring kernel-module-soundcore
Configuring kernel-module-hostap-cs
Configuring kernel-module-g-serial
Configuring kernel-module-airo-cs
Configuring kernel-module-orinoco
Configuring kernel-module-aes-generic
Configuring kernel-module-sco
Configuring kernel-module-uinput
Configuring kernel-module-ieee80211-crypt
Configuring kernel-module-8390
Configuring kernel-module-cifs
Configuring kernel-module-ppp-generic
Configuring kernel-module-hci-uart
Configuring kernel-module-crypto-blkcipher
Configuring kernel-module-irda
Configuring kernel-module-ecb
Configuring kernel-module-hci-vhci
Configuring kernel-module-hermes
Configuring kernel-module-snd-soc-pxa2xx-i2s
Configuring kernel-module-af-packet
Configuring kernel-module-sunrpc
Configuring kernel-module-irnet
Configuring kernel-module-serial-cs
Configuring dbus
System startup links for /etc/init.d/dbus-1 already exist.
Configuring kernel-module-smbfs
Configuring kernel-module-bnep
Configuring kernel-module-airo
Configuring kernel-module-arc4
Configuring kernel-module-gadgetfs
Configuring ppp
Configuring kernel-module-cryptomgr
Configuring kernel-module-ieee80211-crypt-wep
Configuring kernel-module-g-ether
Configuring kernel-module-snd-timer
Configuring kernel-module-snd
Configuring avahi-autoipd
Configuring kernel-module-snd-soc-core
Configuring angstrom-libc-fixup-hack
Configuring kernel-module-snd-pcm
Configuring kernel-module-g-file-storage
Configuring kernel-module-ppp-deflate
Configuring avahi-daemon
System startup links for /etc/init.d/avahi-daemon already exist.
Configuring kernel-module-hid
Configuring kernel-module-bluecard-cs
Configuring kernel-image-2.6.26
Configuring kernel-module-l2cap
Configuring kernel-module-dtl1-cs
Configuring kernel-module-spectrum-cs
Configuring update-modules
Configuring kernel-module-snd-soc-wm8731
Configuring libnss-mdns
Configuring kernel-module-lockd
Bluetooth: Core ver 2.11
NET: Registered protocol family 31
Bluetooth: HCI device and connection manager initialized
Bluetooth: HCI socket layer initialized
Bluetooth: L2CAP ver 2.9
Bluetooth: L2CAP socket layer initialized
Bluetooth: HIDP (Human Interface Emulation) ver 1.2
NET: Registered protocol family 23
IrCOMM protocol (Dag Brattli)
Bluetooth: RFCOMM socket layer initialized
Bluetooth: RFCOMM TTY layer initialized
Bluetooth: RFCOMM ver 1.8
ASoC version 0.13.2
wm8731: WM8731 Audio Codec 0.13
asoc: WM8731 <-> pxa2xx-i2s mapping ok
ether gadget: using random self ethernet address
ether gadget: using random host ethernet address
usb0: Ethernet Gadget, version: May Day 2005
usb0: using pxa2xx_udc, OUT ep2out-bulk IN ep1in-bulk STATUS ep6in-bulk
usb0: MAC 92:6b:83:a4:ff:a3
usb0: HOST MAC 6a:22:3f:8d:4f:45
usb0: RNDIS ready