Something

ifconfig output:
eth2      Link encap:Ethernet  HWaddr 00:15:E9:87:55:06
          inet addr:172.20.15.25  Bcast:172.20.15.255  Mask:255.255.255.0
          inet6 addr: fe80::215:e9ff:fe87:5506/64 Scope:Link
          UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
          RX packets:520 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:50348 (49.1 KiB)  TX bytes:0 (0.0 b)
          Interrupt:11


[root@jupiter2 log]# dmesg | grep skge
skge 1.6 addr 0xdffcc000 irq 11 chip Yukon-Lite rev 9
skge eth2: addr 00:15:e9:87:55:06
skge eth2: enabling interface
skge eth2: Link is up at 1000 Mbps, full duplex, flow control tx and rx

dmesg | grep eth2 output:
skge eth2: enabling interface
skge eth2: Link is up at 1000 Mbps, full duplex, flow control none
eth2: no IPv6 routers present
device eth2 entered promiscuous mode
device eth2 left promiscuous mode

(promiscuous mode is a result of using tshark) 


[root@jupiter2 ~]# route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use Iface
68.XXX.XXX.0    *               255.255.255.128 U     0      0        0 eth0
172.20.15.0     *               255.255.255.0   U     0      0        0 eth2
default         68.XXX.XXX.XXX  0.0.0.0         UG    0      0        0 eth0