LILO 22.7.2
Boot Options:-
openwrt - OpenWrt with usb stick root
ramdisk - OpenWrt with ramdisk root
failsafe - OpenWrt failsafe
boot: openwrt
Loading openwrt
BIOS data check successful
Linux version 2.6.17 (gerry@raidbox) (gcc version 3.4.6 (OpenWrt-2.0)) #109 Fri Aug 18 05:16:28 PDT
2006
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 000000001dff0000 (usable)
BIOS-e820: 000000001dff0000 - 000000001dff3000 (ACPI NVS)
BIOS-e820: 000000001dff3000 - 000000001e000000 (ACPI data)
BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
479MB LOWMEM available.
DMI 2.2 present.
Allocating PCI resources starting at 20000000 (gap: 1e000000:e1ff0000)
Built 1 zonelists
Kernel command line: BOOT_IMAGE=openwrt rootfs=/dev/disc console=ttyS0,115200n81
Initializing CPU#0
PID hash table entries: 2048 (order: 11, 8192 bytes)
scx200hr: timer not yet accessible; will probe later.
Detected 601.382 MHz processor.
Using tsc for high-res timesource
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
Memory: 483376k/491456k available (1071k kernel code, 7520k reserved, 260k data, 1328k init, 0k high
mem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay using timer specific routine.. 1204.59 BogoMIPS (lpj=6022963)
Mount-cache hash table entries: 512
CPU: L1 I Cache: 64K (32 bytes/line), D cache 64K (32 bytes/line)
CPU: L2 Cache: 64K (32 bytes/line)
CPU: Centaur VIA Samuel 2 stepping 03
Checking 'hlt' instruction... OK.
SMP alternatives: switching to UP code
Freeing SMP alternatives: 0k freed
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.10 entry at 0xfad30, last bus=1
Setting up standard PCI resources
Linux Plug and Play Support v0.97 (c) Adam Belay
PCI: Probing PCI hardware
PCI quirk: region 0400-047f claimed by vt8235 PM
PCI quirk: region 0500-050f claimed by vt8235 SMB
PCI: Using IRQ router VIA [1106/3177] at 0000:00:11.0
PCI: Found IRQ 11 for device 0000:00:11.1
PCI: Sharing IRQ 11 with 0000:00:10.0
PCI: Sharing IRQ 11 with 0000:00:12.0
PCI: Bridge: 0000:00:01.0
IO window: disabled.
MEM window: dc000000-ddffffff
PREFETCH window: d8000000-dbffffff
NET: Registered protocol family 2
IP route cache hash table entries: 4096 (order: 2, 16384 bytes)
TCP established hash table entries: 16384 (order: 4, 65536 bytes)
TCP bind hash table entries: 8192 (order: 3, 32768 bytes)
TCP: Hash tables configured (established 16384 bind 8192)
TCP reno registered
scx200: NatSemi SCx200 Driver
squashfs: version 3.0 (2006/03/15) Phillip Lougher
devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
JFFS2 version 2.2. (NAND) (C) 2001-2003 Red Hat, Inc.
Initializing Cryptographic API
io scheduler noop registered
io scheduler deadline registered (default)
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Real Time Clock Driver v1.12ac
Non-volatile memory driver v1.2
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP vegas registered
NET: Registered protocol family 1
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
Using IPI Shortcut mode
Freeing unused kernel memory: 1328k freed
Warning: unable to open an initial console.
usbcore: registered new driver usbfs
usbcore: registered new driver hub
SCSI subsystem initialized
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
USB Universal Host Controller Interface driver v3.0
PCI: Found IRQ 11 for device 0000:00:10.0
PCI: Sharing IRQ 11 with 0000:00:11.1
PCI: Sharing IRQ 11 with 0000:00:12.0
uhci_hcd 0000:00:10.0: UHCI Host Controller
uhci_hcd 0000:00:10.0: new USB bus registered, assigned bus number 1
uhci_hcd 0000:00:10.0: irq 11, io base 0x0000d400
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
PCI: Found IRQ 9 for device 0000:00:10.1
uhci_hcd 0000:00:10.1: UHCI Host Controller
uhci_hcd 0000:00:10.1: new USB bus registered, assigned bus number 2
uhci_hcd 0000:00:10.1: irq 9, io base 0x0000d800
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
PCI: Found IRQ 5 for device 0000:00:10.2
uhci_hcd 0000:00:10.2: UHCI Host Controller
uhci_hcd 0000:00:10.2: new USB bus registered, assigned bus number 3
uhci_hcd 0000:00:10.2: irq 5, io base 0x0000dc00
usb usb3: configuration #1 chosen from 1 choice
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 2 ports detected
usb 2-1: new full speed USB device using uhci_hcd and address 2
usb 2-1: configuration #1 chosen from 1 choice
scsi0 : SCSI emulation for USB Mass Storage devices
Vendor: POWERDAT Model: POWERDATA Rev: 1.00
Type: Direct-Access ANSI SCSI revision: 00
SCSI device sda: 260448 512-byte hdwr sectors (133 MB)
sda: Write Protect is off
sda: assuming drive cache: write through
devfs_mk_dir: invalid argument.<5>SCSI device sda: 260448 512-byte hdwr sectors (133 MB)
sda: Write Protect is off
sda: assuming drive cache: write through
sda:
sd 0:0:0:0: Attached scsi removable disk sda
EXT2-fs warning (device sda): ext2_fill_super: mounting ext3 filesystem as ext2
mount: Mounting none on /dev failed: Device or resource busy
init started: BusyBox v1.2.1 (2006.08.17-21:15+0000) multi-call binary
Please press Enter to activate this console. via-rhine.c:v1.10-LK1.2.0-2.6 June-10-2004 Written by D
onald Becker
PCI: Found IRQ 10 for device 0000:00:0f.0
PCI: Sharing IRQ 10 with 0000:00:10.3
eth0: VIA Rhine III at 0x1d000, 00:40:63:da:d8:bf, IRQ 10.
eth0: MII PHY found at address 1, status 0x786d advertising 05e1 Link 45e1.
PCI: Found IRQ 11 for device 0000:00:12.0
PCI: Sharing IRQ 11 with 0000:00:10.0
PCI: Sharing IRQ 11 with 0000:00:11.1
eth1: VIA Rhine II at 0x1e400, 00:40:63:da:d8:f1, IRQ 11.
eth1: MII PHY found at address 1, status 0x7849 advertising 05e1 Link 0000.
eth0: link up, 100Mbps, full-duplex, lpa 0x45E1
eth1: link down
BusyBox v1.2.1 (2006.08.17-21:15+0000) Built-in shell (ash)
Enter 'help' for a list of built-in commands.
_______ ________ __
| |.-----.-----.-----.| | | |.----.| |_
| - || _ | -__| || | | || _|| _|
|_______|| __|_____|__|__||________||__| |____|
|__| W I R E L E S S F R E E D O M
KAMIKAZE (bleeding edge, r4569) -------------------
* 10 oz Vodka Shake well with ice and strain
* 10 oz Triple sec mixture into 10 shot glasses.
* 10 oz lime juice Salute!
---------------------------------------------------
root@OpenWrt:/# mount
none on /proc type proc (rw)
none on /dev type devfs (rw)
none on /proc/bus/usb type usbfs (rw)
/dev/disc on / type ext2 (rw)
root@OpenWrt:/# df
Filesystem 1k-blocks Used Available Use% Mounted on
/dev/disc 127151 6106 115837 5% /
root@OpenWrt:/# free
total used free shared buffers
Mem: 484876 5232 479644 0 124
Swap: 0 0 0
Total: 484876 5232 479644
root@OpenWrt:/# uname -r
2.6.17
root@OpenWrt:/#