Anonymous

Linux version 2.6.17 (root@colinux) (gcc version 3.4.4 (OpenWrt-2.0)) #1 Wed Aug 2 15:53:00 PDT 2006
CPU revision is: 00029007
early_nvram_init: WGT634U NVRAM found.
Determined physical RAM map:
 memory: 02000000 @ 00000000 (usable)
On node 0 totalpages: 8192
  DMA zone: 8192 pages, LIFO batch:1
Built 1 zonelists
Kernel command line: root=/dev/mtdblock2 rootfstype=squashfs,jffs2 init=/etc/preinit noinitrd console=ttyS0,115200
Primary instruction cache 8kB, physically tagged, 2-way, linesize 16 bytes.
Primary data cache 4kB, 2-way, linesize 16 bytes.
Synthesized TLB refill handler (19 instructions).
Synthesized TLB load handler fastpath (31 instructions).
Synthesized TLB store handler fastpath (31 instructions).
Synthesized TLB modify handler fastpath (30 instructions).
PID hash table entries: 256 (order: 8, 1024 bytes)
Using 100.000 MHz high precision timer.
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 30048k/32768k available (1871k kernel code, 2704k reserved, 260k data, 128k init, 0k highmem)
Calibrating delay loop... 197.63 BogoMIPS (lpj=98816)
Mount-cache hash table entries: 512
Checking for 'wait' instruction...  unavailable.
NET: Registered protocol family 16
PCI: fixing up bridge
PCI: Setting latency timer of device 0000:01:00.0 to 64
PCI: Fixing up device 0000:01:00.0
NET: Registered protocol family 2
IP route cache hash table entries: 256 (order: -2, 1024 bytes)
TCP established hash table entries: 1024 (order: 0, 4096 bytes)
TCP bind hash table entries: 512 (order: -1, 2048 bytes)
TCP: Hash tables configured (established 1024 bind 512)
TCP reno registered
squashfs: version 3.0 (2006/03/15) Phillip Lougher
devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
JFFS2 version 2.2. (NAND) (C) 2001-2003 Red Hat, Inc.
Initializing Cryptographic API
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x0 (irq = 3) is a 16550A
serial8250: ttyS1 at MMIO 0x0 (irq = 3) is a 16550A
b44.c:v1.00 (Apr 7, 2006)
PCI: Enabling device 0000:00:01.0 (0000 -> 0002)
PCI: Setting latency timer of device 0000:00:01.0 to 64
eth0: Broadcom 47xx 10/100BaseT Ethernet 00:09:5b:f8:10:eb
Physically mapped flash: Found 1 x16 devices at 0x0 in 16-bit bank
 Intel/Sharp Extended Query Table at 0x0031
Using buffer write method
cfi_cmdset_0001: Erase suspend on write enabled
erase region 0: offset=0x0,size=0x20000,blocks=64
Flash device: 0x800000 at 0x1c000000
bootloader size: 655360
Creating 4 MTD partitions on "Physically mapped flash":
0x00000000-0x000a0000 : "cfe"
0x000a0000-0x007e0000 : "linux"
0x00160000-0x007e0000 : "rootfs"
0x007e0000-0x00800000 : "nvram"
ip_conntrack version 2.4 (256 buckets, 2048 max) - 236 bytes per conntrack
ip_tables: (C) 2000-2006 Netfilter Core Team
TCP vegas registered
NET: Registered protocol family 1
NET: Registered protocol family 17
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (jffs2 filesystem) readonly.
Mounted devfs on /dev
Freeing unused kernel memory: 128k freed
Algorithmics/MIPS FPU Emulator v1.5
b44: eth0: Link is up at 100 Mbps, full duplex.
b44: eth0: Flow control is off for TX and off for RX.
eth0.0: dev_set_promiscuity(master, 1)
device eth0 entered promiscuous mode
device eth0.0 entered promiscuous mode
br-lan: port 1(eth0.0) entering learning state
br-lan: topology change detected, propagating
br-lan: port 1(eth0.0) entering forwarding state
wlan: 0.8.4.2 (0.9.0)
ath_hal: module license 'Proprietary' taints kernel.
ath_hal: 0.9.16.16 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413)
ath_rate_sample: 1.2 (0.9.0)
wlan: mac acl policy registered
ath_pci: 0.9.4.5 (0.9.0)
PCI: Enabling device 0000:01:01.0 (0000 -> 0002)
PCI: Fixing up device 0000:01:01.0
ath_pci: switching rfkill capability off
wifi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
wifi0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
wifi0: turboG rates: 6Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps
wifi0: H/W encryption support: WEP AES AES_CCM TKIP
wifi0: mac 5.9 phy 4.3 radio 4.6
wifi0: Use hw queue 1 for WME_AC_BE traffic
wifi0: Use hw queue 0 for WME_AC_BK traffic
wifi0: Use hw queue 2 for WME_AC_VI traffic
wifi0: Use hw queue 3 for WME_AC_VO traffic
wifi0: Use hw queue 8 for CAB traffic
wifi0: Use hw queue 9 for beacons
wifi0: Atheros 5212: mem=0x40000000, irq=2
Probing device eth0: found!
BFL_ENETADM not set in boardflags. Use force=1 to ignore.
eth0.1: add 01:00:5e:00:00:01 mcast address to master interface
usbcore: registered new driver usbfs
usbcore: registered new driver hub
ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
PCI: Enabling device 0000:00:03.0 (0000 -> 0002)
PCI: Setting latency timer of device 0000:00:03.0 to 64
ohci_hcd 0000:00:03.0: OHCI Host Controller
ohci_hcd 0000:00:03.0: new USB bus registered, assigned bus number 1
ohci_hcd 0000:00:03.0: irq 6, io mem 0x18003000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
PCI: Enabling device 0000:01:02.0 (0000 -> 0002)
PCI: Fixing up device 0000:01:02.0
PCI: Setting latency timer of device 0000:01:02.0 to 64
ohci_hcd 0000:01:02.0: OHCI Host Controller
ohci_hcd 0000:01:02.0: new USB bus registered, assigned bus number 2
ohci_hcd 0000:01:02.0: irq 2, io mem 0x40010000
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 1 port detected
usb 1-1: new low speed USB device using ohci_hcd and address 2
PCI: Enabling device 0000:01:02.1 (0000 -> 0002)
PCI: Fixing up device 0000:01:02.1
PCI: Setting latency timer of device 0000:01:02.1 to 64
ohci_hcd 0000:01:02.1: OHCI Host Controller
ohci_hcd 0000:01:02.1: new USB bus registered, assigned bus number 3
ohci_hcd 0000:01:02.1: irq 2, io mem 0x40011000
usb usb3: configuration #1 chosen from 1 choice
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 1 port detected
ohci_hcd 0000:00:03.0: Unlink after no-IRQ?  Controller is probably using the wrong IRQ.
root@OpenWrt:/#