rendered paste bodyCobalt:Main Menu> bfn
Enabling L2 cache: done
First stage kernel (Linux): Decompressing - done
ERROR: cannot relocate with filesize 0
command line: 'console=ttyS0,115200 debug ip=on root=/dev/nfs nfsroot=/nfsroot-x86,rsize=8192 '
booting kernel...
Linux version 2.4.25-ROM (duncan@atherton) (gcc version 3.3.3 (Debian 20040306)) #1 Thu Mar 11 08:47:53 M4
BIOS-provided physical RAM map:
BIOS-e801: 0000000000000000 - 000000000009f000 (usable)
BIOS-e801: 0000000000100000 - 0000000020000000 (usable)
512MB LOWMEM available.
On node 0 totalpages: 131072
zone(0): 4096 pages.
zone(1): 126976 pages.
zone(2): 0 pages.
DMI not present.
Kernel command line: console=ttyS0,115200 debug ip=on root=/dev/nfs nfsroot=/nfsroot-x86,rsize=8192
Initializing CPU#0
Detected 298.813 MHz processor.
Calibrating delay loop... 596.37 BogoMIPS
Memory: 516556k/524288k available (1141k kernel code, 7344k reserved, 244k data, 100k init, 0k highmem)
Dentry cache hash table entries: 65536 (order: 7, 524288 bytes)
Inode cache hash table entries: 32768 (order: 6, 262144 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 32768 (order: 5, 131072 bytes)
Page-cache hash table entries: 131072 (order: 7, 524288 bytes)
Enabling new style K6 write allocation for 512 Mb
CPU: L1 I Cache: 32K (32 bytes/line), D cache 32K (32 bytes/line)
CPU: After generic, caps: 008021bf 808029bf 00000000 00000002
CPU: Common caps: 008021bf 808029bf 00000000 00000002
CPU: AMD-K6(tm) 3D processor stepping 0c
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: AMD K6
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
VFS: Disk quotas vdquot_6.5.1
Journalled Block Device driver loaded
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
Real Time Clock Driver v1.10f
Non-volatile memory driver v1.2
loop: loaded (max 8 devices)
eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html
eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin <saw@saw.sw.com.sg> and others
eth0: Invalid EEPROM checksum 0xc59e, check settings before activating this device!
eth0: PCI device 8086:1209, 00:10:E0:01:BE:B3, IRQ 11.
Receiver lock-up bug exists -- enabling work-around.
Board assembly 000000-000, Physical connectors present:
Primary interface chip None PHY #0.
General self-test: passed.
Serial sub-system self-test: passed.
Internal registers self-test: passed.
ROM checksum self-test: passed (0xdbd8681d).
Receiver lock-up workaround activated.
eth1: Invalid EEPROM checksum 0xc49e, check settings before activating this device!
eth1: PCI device 8086:1209, 00:10:E0:01:BE:B2, IRQ 10.
Receiver lock-up bug exists -- enabling work-around.
Board assembly 000000-000, Physical connectors present:
Primary interface chip None PHY #0.
General self-test: passed.
Serial sub-system self-test: passed.
Internal registers self-test: passed.
ROM checksum self-test: passed (0xdbd8681d).
Receiver lock-up workaround activated.
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ALI15X3: IDE controller at PCI slot 00:0f.0
ALI15X3: chipset revision 193
ALI15X3: 100% native mode on irq 14
ide0: BM-DMA at 0xfdd0-0xfdd7, BIOS settings: hda:DMA, hdb:DMA
ide1: BM-DMA at 0xfdd8-0xfddf, BIOS settings: hdc:DMA, hdd:DMA
hda: Maxtor 2R010H1, ATA DISK drive
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
blk: queue c0298fa0, I/O limit 4095Mb (mask 0xffffffff)
ide0 at 0xfdf8-0xfdff,0xfdf6 on irq 14
hda: attached ide-disk driver.
Unable to handle kernel paging request at virtual address e1ef3168
printing eip:
c01292f5
*pde = 00000000
Oops: 0000
CPU: 0
EIP: 0010:[<c01292f5>] Not tainted
EFLAGS: 00010012
eax: 00800044 ebx: 00800044 ecx: dfef3040 edx: 00000080
esi: c1587270 edi: 00000246 ebp: dfed30e0 esp: c159df20
ds: 0018 es: 0018 ss: 0018
Process swapper (pid: 1, stackpage=c159d000)
Stack: 00000000 ffffffff c0238f13 00000010 c014fde9 c1587270 000001f0 00000001
00008100 c0238f02 c0256dd0 00008100 c0298f90 01ffff20 c014ffcf c159df80
c0238f02 00008100 00000001 c0256dd0 dfed39e0 c01abe04 c0238f02 00008100
Call Trace: [<c014fde9>] [<c014ffcf>] [<c01abe04>] [<c01a8cc6>] [<c0105000>]
[<c01b2c1f>] [<c0105067>] [<c0105733>] [<c0105060>]
Code: 8b 44 81 18 0f af da 89 41 14 01 eb 40 74 09 57 9d 89 d8 5b
<0>Kernel panic: Attempted to kill init!