rendered paste bodyEFI v1.10 by INTEL: SALsystab=0x30027c8df0 ACPI 2.0=0x30027c95c0
Number of logical nodes in system = 1
Number of memory chunks in system = 1
SAL 2.9: SGI SN2 version 4.33
SAL Platform features: ITC_Drift
SAL: AP wakeup using external interrupt vector 0x12
No logical to physical processor mapping available
ACPI: Local APIC address c0000000fee00000
ACPI: Error parsing MADT - no IOSAPIC entries
register_intr: No IOSAPIC for GSI 52
2 CPUs available, 2 CPUs total
Increasing MCA rendezvous timeout from 20000 to 49000 milliseconds
MCA related initialization done
SGI SAL version 4.33
Virtual mem_map starts at 0xa0007fffd1a70000
Built 1 zonelists
Kernel command line: BOOT_IMAGE=scsi0:/EFI/debian/boot/vmlinuz root=/dev/sda3 nohalt noresume console=ttySG0 115200 ro
PID hash table entries: 4096 (order: 12, 32768 bytes)
Console: colour dummy device 80x25
Memory: 5987936k/6017696k available (6356k code, 39280k reserved, 2557k data, 368k init)
McKinley Errata 9 workaround not needed; disabling it
Dentry cache hash table entries: 1048576 (order: 9, 8388608 bytes)
Inode-cache hash table entries: 524288 (order: 8, 4194304 bytes)
Mount-cache hash table entries: 1024
Boot processor id 0x0/0x0
Brought up 2 CPUs
Total of 2 processors activated (4489.21 BogoMIPS).
migration_cost=11282
DMI not present or invalid.
NET: Registered protocol family 16
ACPI: bus type pci registered
Altix IO Topology Information
*****************************
Serial Number:R2000356
PCI SEGMENT PCIBUS NUMBER BRICK RACK:SLOT BUS CONNECTION TOPOLOGY
----------- ------------- --------------------- -------------------
0x0001 0x01 OPbrick 001:01 01 001c01:slab0:widget15:bus0
0x0002 0x01 OPbrick 001:01 02 001c01:slab0:widget15:bus1
0x0002 0x02 PPB Device on PCI Bus Number 0x01 Device Number 1
PROM version < 4.50 -- implementing old PROM flush WAR
ACPI: Subsystem revision 20060127
ACPI: SCI (ACPI GSI 52) not registered
ACPI: Interpreter enabled
ACPI: Using IOSAPIC for interrupt routing
SCSI subsystem initialized
NET: Registered protocol family 2
IP route cache hash table entries: 262144 (order: 7, 2097152 bytes)
TCP established hash table entries: 1048576 (order: 10, 16777216 bytes)
TCP bind hash table entries: 65536 (order: 6, 1048576 bytes)
TCP: Hash tables configured (established 1048576 bind 65536)
TCP reno registered
perfmon: version 2.0 IRQ 238
perfmon: Itanium 2 PMU detected, 16 PMCs, 18 PMDs, 4 counters (47 bits)
PAL Information Facility v0.5
perfmon: added sampling format default_format
perfmon_default_smpl: default_format v2.0 registered
audit: initializing netlink socket (disabled)
audit(1151668659.528:1): initialized
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 2048 (order 0, 16384 bytes)
SGI XFS with ACLs, security attributes, large block/inode numbers, no debug enabled
SGI XFS Quota Management subsystem
Initializing Cryptographic API
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
EFI Time Services Driver v0.4
Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing enabled
sn_console: Console driver init
ttySG0 at I/O 0x0 (irq = 0) is a SGI SN L1
RAMDISK driver initialized: 16 RAM disks of 32768K size 1024 blocksize
tg3.c:v3.59 (June 8, 2006)
ACPI: PCI Interrupt 0001:01:04.0[A]: no GSI
eth0: Tigon3 [partno(030-1771-000) rev 0105 PHY(5701)] (PCI:66MHz:64-bit) 10/100/1000BaseT Ethernet 08:00:69:13:ee:0d
eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] Split[0] WireSpeed[1] TSOcap[0]
eth0: dma_rwctrl[76ff3f0f] dma_mask[64-bit]
qla1280: QLA12160 found on PCI bus 1, dev 3
ACPI: PCI Interrupt 0001:01:03.0[A]: no GSI
scsi(0): Enabling SN2 PCI DMA dual channel lockup workaround
scsi(0): Enabling SN2 PCI DMA workaround
scsi(0:0): Resetting SCSI BUS
scsi(0:1): Resetting SCSI BUS
scsi0 : QLogic QLA12160 PCI to SCSI Host Adapter
Firmware version: 10.04.42, Driver version 3.26
Vendor: SGI Model: ST373405LC Rev: 2744
Type: Direct-Access ANSI SCSI revision: 03
scsi(0:0:1:0): Sync: period 9, offset 14, Wide, DT
Vendor: SGI Model: ST373405LC Rev: 2744
Type: Direct-Access ANSI SCSI revision: 03
scsi(0:0:2:0): Sync: period 9, offset 14, Wide, DT
QLogic Fibre Channel HBA Driver
megaraid cmm: 2.20.2.6 (Release Date: Mon Mar 7 00:01:03 EST 2005)
megaraid: 2.20.4.8 (Release Date: Mon Apr 11 12:27:22 EST 2006)
megaraid: probe new device 0x1000:0x0407:0x8086:0x0532: bus 2:slot 0:func 0
ACPI: PCI Interrupt 0002:02:00.0[A]: no GSI
megaraid mailbox: wait for FW to boot [ok]
Entered OS MCA handler. PSP=20000000fff21120 cpu=0 monarch=1
All OS MCA slaves have reached rendezvous