I'm playing around with emc2 and I'm using axis. I am having a problem when I
go to touch off any axis. When I enter anything into the box that isn't the
correct format, it instantly says it's the wrong format and doesn't allow me to
click ok, even if I change it to the right format, so I have to cancel and do it
again. So if I put in "0.0\" accidentally, it says bad format and grays out the
ok button. Or if I put in "1..0".
Is this an axis problem? Or is it a problem with the gui software?
I've done quite a bit of programming, so if you'd like me to check some things,
or can direct me on where I should look to fix it, that would be ok.
It's just frustrating when I go to touch off and have to cancel over and over
because I hit the wrong key accidentally.