rendered paste bodysmartctl 6.2 2013-11-07 r3856 [x86_64-linux-4.1.15-8-default] (SUSE RPM)
Copyright (C) 2002-13, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Model Family: Seagate Constellation ES (SATA 6Gb/s)
Device Model: ST1000NM0011
Serial Number:
LU WWN Device Id: 5 000c50 035106cc9
Firmware Version: SN03
User Capacity: 1,000,204,886,016 bytes [1.00 TB]
Sector Size: 512 bytes logical/physical
Rotation Rate: 7202 rpm
Device is: In smartctl database [for details use: -P show]
ATA Version is: ATA8-ACS T13/1699-D revision 4
SATA Version is: SATA 3.0, 6.0 Gb/s (current: 6.0 Gb/s)
Local Time is: Tue Feb 2 18:43:05 2016 MSK
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x82) Offline data collection activity
was completed without error.
Auto Offline Data Collection: Enabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 609) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 155) minutes.
Conveyance self-test routine
recommended polling time: ( 2) minutes.
SCT capabilities: (0x10bd) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 10
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
1 Raw_Read_Error_Rate 0x000f 080 051 044 Pre-fail Always - 107572489
3 Spin_Up_Time 0x0003 097 092 000 Pre-fail Always - 0
4 Start_Stop_Count 0x0032 099 099 020 Old_age Always - 1300
5 Reallocated_Sector_Ct 0x0033 091 091 036 Pre-fail Always - 397
7 Seek_Error_Rate 0x000f 091 060 030 Pre-fail Always - 1498448616
9 Power_On_Hours 0x0032 064 064 000 Old_age Always - 31552
10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0
12 Power_Cycle_Count 0x0032 099 099 020 Old_age Always - 1254
184 End-to-End_Error 0x0032 100 100 099 Old_age Always - 0
187 Reported_Uncorrect 0x0032 038 038 000 Old_age Always - 62
188 Command_Timeout 0x0032 100 099 000 Old_age Always - 4295098413
189 High_Fly_Writes 0x003a 100 100 000 Old_age Always - 0
190 Airflow_Temperature_Cel 0x0022 066 050 045 Old_age Always - 34 (Min/Max 21/35)
191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 825
192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 244
193 Load_Cycle_Count 0x0032 100 100 000 Old_age Always - 1674
194 Temperature_Celsius 0x0022 034 050 000 Old_age Always - 34 (0 12 0 0 0)
195 Hardware_ECC_Recovered 0x001a 116 099 000 Old_age Always - 107572489
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 1
SMART Error Log Version: 1
ATA Error Count: 132 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 132 occurred at disk power-on lifetime: 31500 hours (1312 days + 12 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 ff ff ff 0f Error: UNC at LBA = 0x0fffffff = 268435455
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
60 00 78 ff ff ff 4f 00 22:16:36.831 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 22:16:36.831 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 22:16:36.831 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 22:16:36.831 READ FPDMA QUEUED
60 00 08 ff ff ff 4f 00 22:16:36.831 READ FPDMA QUEUED
Error 131 occurred at disk power-on lifetime: 31066 hours (1294 days + 10 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 25 9d ba 00 Error: WP at LBA = 0x00ba9d25 = 12229925
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 08 c0 92 65 40 00 00:00:48.866 WRITE FPDMA QUEUED
61 00 08 28 3f 5e 40 00 00:00:48.866 WRITE FPDMA QUEUED
61 00 08 38 8e 65 40 00 00:00:48.866 WRITE FPDMA QUEUED
61 00 08 f0 84 5e 40 00 00:00:48.866 WRITE FPDMA QUEUED
61 00 08 58 4b 06 40 00 00:00:48.866 WRITE FPDMA QUEUED
Error 130 occurred at disk power-on lifetime: 31066 hours (1294 days + 10 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 1c 9d ba 00 Error: WP at LBA = 0x00ba9d1c = 12229916
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 08 78 78 65 40 00 00:00:39.542 WRITE FPDMA QUEUED
61 00 08 18 48 76 47 00 00:00:39.542 WRITE FPDMA QUEUED
61 00 08 40 4b 06 40 00 00:00:39.541 WRITE FPDMA QUEUED
61 00 08 f0 77 65 40 00 00:00:39.541 WRITE FPDMA QUEUED
61 00 08 e8 83 5e 40 00 00:00:39.541 WRITE FPDMA QUEUED
Error 129 occurred at disk power-on lifetime: 31066 hours (1294 days + 10 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 10 9d ba 00 Error: WP at LBA = 0x00ba9d10 = 12229904
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 08 f0 77 65 40 00 00:00:29.146 WRITE FPDMA QUEUED
61 00 08 e8 83 5e 40 00 00:00:29.145 WRITE FPDMA QUEUED
61 00 08 78 77 65 40 00 00:00:29.145 WRITE FPDMA QUEUED
61 00 08 a8 d0 8d 40 00 00:00:29.145 WRITE FPDMA QUEUED
61 00 08 18 3f 5e 40 00 00:00:29.144 WRITE FPDMA QUEUED
Error 128 occurred at disk power-on lifetime: 31066 hours (1294 days + 10 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 00 d8 9c ba 00 Error: WP at LBA = 0x00ba9cd8 = 12229848
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
61 00 08 50 80 58 44 00 00:00:18.708 WRITE FPDMA QUEUED
61 00 d8 10 83 5e 40 00 00:00:18.708 WRITE FPDMA QUEUED
61 00 70 88 05 30 45 00 00:00:18.698 WRITE FPDMA QUEUED
61 00 88 d8 6e f5 45 00 00:00:18.698 WRITE FPDMA QUEUED
61 00 70 ff ff ff 4f 00 00:00:18.698 WRITE FPDMA QUEUED
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 31493 -
# 2 Short offline Completed without error 00% 31493 -
# 3 Short offline Completed without error 00% 23611 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.