Untitled

empire@empire-K55A:~/mesaflash$ ./mesaflash
Configuration program for mesanet 5I25/6I25/7I80 boards
PCI device syntax:
    mesaflash --scanpci
    mesaflash --device device_name [--verbose] [[--recover] --write filename]
    mesaflash --device device_name [--verbose] [--verify filename]
ETH device syntax:
    mesaflash --scaneth x.x.x.0
    mesaflash --device device_name [--verbose] [--ip x.x.x.x] [--write | --verify filename]
    mesaflash --device device_name [--ip x.x.x.x] --set param=value
    mesaflash --device device_name [--ip x.x.x.x] (--rpo addr | --wpo addr=value)
    mesaflash --device device_name [--ip x.x.x.x] --hm2
COMMON syntax:
    mesaflash --info filename
Options:
  --scanpci     detect all pci(e) boards
  --scaneth     detect all ethernet boards in given class C address (mask 255.255.255.0)
  --device      select active device name (currently 5I25 | 6I25 | 7I80)
  --write       write filename into flash (IMPORTANT! filename must be VALID FPGA configuration file)
  --verify      verify if 'filename' is properly programmed in flash
  --recover     write filename into flash using PCI bridge (currently only 6I25)
  --ip          set ip address for connecting 7i80
  --info        print info about configuration in filename
  --verbose     print detailed information while running commands
  --set         set 7I80 eeprom variable
  --rpo         read hostmot2 variable directly
  --wpo         write hostmot2 variable directly
  --hm2         write all hostmot2 info in PIN file format
    ip=x.x.x.x  set board ethernet eeprom ip address
empire@empire-K55A:~/mesaflash$