Advertising
- raspberrypi.gen.tr | rtorrent.rc
- Friday, August 10th, 2012 at 2:33:11pm MDT
- # This is an example resource file for rTorrent. Copy to
- # ~/.rtorrent.rc and enable/modify the options as needed. Remember to
- # uncomment the options you wish to enable.
- #
- # Based on original .rtorrent.rc file from http://libtorrent.rakshasa.no/
- # Modified by Lemonberry for rtGui http://rtgui.googlecode.com/
- #
- # This assumes the following directory structure:
- #
- # /Torrents/Downloading - temporaray location for torrents while downloading (see "directory")
- # /Torrents/Complete - Torrents are moved here when complete (see "on_finished")
- # /Torrents/TorrentFiles/Auto - The 'autoload' directory for rtorrent to use. Place a file
- # in here, and rtorrent loads it #automatically. (see "schedule = watch_directory")
- # /Torrents/Downloading/rtorrent.session - for storing rtorrent session information
- #
- # Maximum and minimum number of peers to connect to per torrent.
- #min_peers = 40
- max_peers = 100
- # Same as above but for seeding completed torrents (-1 = same as downloading)
- min_peers_seed = -1
- max_peers_seed = -1
- # Maximum number of simultanious uploads per torrent.
- max_uploads = 50
- # Global upload and download rate in KiB. "0" for unlimited.
- download_rate = 0
- upload_rate = 0
- # Default directory to save the downloaded torrents.
- directory = /home/downloads/<username>
- # Default session directory. Make sure you don't run multiple instance
- # of rtorrent using the same session directory. Perhaps using a
- # relative path?
- session = /media/rtorrent/session
- # Watch a directory for new torrents, and stop those that have been
- # deleted.
- schedule = watch_directory,5,5,load_start=/home/downloads/<username>/watch/*.torrent
- schedule = untied_directory,5,5,stop_untied=
- # Close torrents when diskspace is low. */
- schedule = low_diskspace,5,60,close_low_diskspace=100M
- # Stop torrents when reaching upload ratio in percent,
- # when also reaching total upload in bytes, or when
- # reaching final upload ratio in percent.
- # example: stop at ratio 2.0 with at least 200 MB uploaded, or else ratio 20.0
- #schedule = ratio,60,60,stop_on_ratio=200,200M,2000
- # When the torrent finishes, it executes "mv -n <base_path> ~/Download/"
- # and then sets the destination directory to "~/Download/". (0.7.7+)
- # on_finished = move_complete,"execute=mv,-u,$d.get_base_path=,/home/downloads/<username>/complete/ ;d.set_directory=/home/downloads/<username>/complete/"
- # The ip address reported to the tracker.
- #ip = 127.0.0.1
- #ip = rakshasa.no
- # The ip address the listening socket and outgoing connections is
- # bound to.
- #bind = 127.0.0.1
- #bind = rakshasa.no
- # Port range to use for listening.
- port_range = 55995-56000
- # Start opening ports at a random position within the port range.
- #port_random = yes
- scgi_port = 127.0.0.1:5000
- # Check hash for finished torrents. Might be usefull until the bug is
- # fixed that causes lack of diskspace not to be properly reported.
- #check_hash = no
- # Set whetever the client should try to connect to UDP trackers.
- #use_udp_trackers = no
- # Alternative calls to bind and ip that should handle dynamic ip's.
- #schedule = ip_tick,0,1800,ip=rakshasa
- #schedule = bind_tick,0,1800,bind=rakshasa
- # Encryption options, set to none (default) or any combination of the following:
- # allow_incoming, try_outgoing, require, require_RC4, enable_retry, prefer_plaintext
- #
- # The example value allows incoming encrypted connections, starts unencrypted
- # outgoing connections but retries with encryption if they fail, preferring
- # plaintext to RC4 encryption after the encrypted handshake
- #
- encryption = allow_incoming,enable_retry,prefer_plaintext
- # Enable DHT support for trackerless torrents or when all trackers are down.
- # May be set to "disable" (completely disable DHT), "off" (do not start DHT),
- # "auto" (start and stop DHT as needed), or "on" (start DHT immediately).
- # The default is "off". For DHT to work, a session directory must be defined.
- #
- dht = disable
- # UDP port to use for DHT.
- #
- # dht_port = 6881
- # Enable peer exchange (for torrents not marked private)
- #
- peer_exchange = no
- #
- # Do not modify the following parameters unless you know what you're doing.
- #
- # Example of scheduling commands: Switch between two ip's every 5
- # seconds.
- #schedule = "ip_tick1,5,10,ip=torretta"
- #schedule = "ip_tick2,10,10,ip=lampedusa"
- # Remove a scheduled event.
- #schedule_remove = "ip_tick1"
advertising
Update the Post
Either update this post and resubmit it with changes, or make a new post.
You may also comment on this post.
Please note that information posted here will expire by default in one month. If you do not want it to expire, please set the expiry time above. If it is set to expire, web search engines will not be allowed to index it prior to it expiring. Items that are not marked to expire will be indexable by search engines. Be careful with your passwords. All illegal activities will be reported and any information will be handed over to the authorities, so be good.